1993 7.3 idi

[tonybullitt]

Thanks I wondered if the early psd ones might be the same.

[tuff57]

hmm i don't think i even knew about those rubber seals, is there one in each hard line? i'm going to reseal the other bank of injectors, and change those seals and perform a vaccum test and hopefully it holds. Keith is that the part number for the seal kit I will need? Hopefully my dealer will be able to find a parts break down for the o-rings or at least a size so I can pick them up in viton

[Keith Browning]

I figured out what is in the kit and this kit actually is not what you need. Sorry bout that. The part number I listed has the following sizes:

[*]4 - 1/4" sleeves [*]1 - 5/16" sleeve [*]1 - 3/8" sleeve

If I recall you need one 3/8" sleeve for the fuel pump to filter head line and two 5/16" sleeves for the filter head to injection pump line.
 
I found these part numbers:
Fuel line seals--filter to injection pump E3TZ-9K260-A
Fuel line seals--fuel filter inlet; return line from injection pump (rear only on some applications)   E3TZ-9C387-A
 

[tuff57]

I figured out what is in the kit and this kit actually is not what you need. Sorry bout that. The part number I listed has the following sizes:

[*]4 - 1/4" sleeves

[*]1 - 5/16" sleeve

[*]1 - 3/8" sleeve

If I recall you need one 3/8" sleeve for the fuel pump to filter head line and two 5/16" sleeves for the filter head to injection pump line.

 

I found these part numbers:

Fuel line seals--filter to injection pump E3TZ-9K260-A

Fuel line seals--fuel filter inlet; return line from injection pump (rear only on some applications)   E3TZ-9C387-A

 

 

thanks keith, it's greatly appreciated!