E4OD / 4R100 speedi-sleeve for torque converter hub

Jeff_E · December 10, 2015

Anybody have a brand and part number for one, I've been searching with no luck. Thanks in advance.

JoeR · December 11, 2015

Sonnax makes a slightly oversized pump bushing to cure loose fit of the converter hub. You need to do the final fit on your own. Is this what you're looking for?

http://www.sonnax.com/parts/2048-pump-bushing

If so, I get almost all my Sonnax stuff from Transtar.

Joe

Brad Clayton · December 11, 2015

That's cool, I used to ride by this place on my to work everyday. It's a small little joint and a co-worker's wife worked there also.

Jeff_E · December 11, 2015

That bushing may not be a bad idea too, but i'm looking for something I can use to fix the actual torque converter which has a groove worn in it from the seal, I don't want to have a repeat seal failure.

Buddy_M · December 11, 2015

Try a 99200 speedi sleeve from napa. I think hub diamater is 2.00" so that should be right number. Measure your hub and a good parts counterman should be able to reference it in their book if I'm wrong from memory. Repair sleeve numbers are quite easy too, the last 3 in the part number denotes approx shaft size it fits.